I'm in the midst of getting everything together to swap my 97 OBS to an EJ205. For now, I'm going to run a conservative tune and keep the stock drivetrain since I rebuilt the tranny literally 5000 miles ago. Which creates a bit of an issue, being that I still have the speedo cable from the transmission.
I want to do the GD dash and gauge cluster, but obviously the cable won't work with that. Is is simply a matter of swapping out where the cable goes into the tranny in favor of the speed sensor, or would I be looking at having to open the tranny to change that out (See; sucking it up and getting a WRX 5 speed instead of all that work again) Or is there a way to tap into the speed signal to the ECU (Unless it's read at the gauge end of the cable?) and make that work on the GD speedo?
Thanks in advance. I hope this is any easy thing and I just suck at using the search function...
I want to do the GD dash and gauge cluster, but obviously the cable won't work with that. Is is simply a matter of swapping out where the cable goes into the tranny in favor of the speed sensor, or would I be looking at having to open the tranny to change that out (See; sucking it up and getting a WRX 5 speed instead of all that work again) Or is there a way to tap into the speed signal to the ECU (Unless it's read at the gauge end of the cable?) and make that work on the GD speedo?
Thanks in advance. I hope this is any easy thing and I just suck at using the search function...